Tricks Tips Soldering

Then once we close the core wire the molten soldering takes its place above the spot to cover the whole spot surface and to connect the component foot to the circuits spot.

Tricks tips soldering. This would help in making the tip. Do not move the joint until the solder has cooled. Take the soldering iron in your dominant hand and quickly touch it to the metal prong and the solder.

6040 solder is recommended for beginners. Before starting tin the soldering tip by adding fresh wire solder to it. It cools quickly and keeps you from frying the solder to the tip.

Use the thinnest solder appropriate for your project. Then wipe it off on a wet sponge removing everything except a thin layer of solder. In order to empty the solder sucker press down on the plunger.

There are two techniques used to apply the solder. Pressing the hot tip into the tinning compound will allow you to coat the tip. We clean the soldering tip and we place the components one by one so I will solder this IC socket which has 16 pins.

The number of likes on this last one indicates this little trick was new for many people. Melted solder flows towards heat. Use the correct type of vise or third hand.

2 You can buy a solder removing vacuum tube. Keep your soldering iron tip clean. Remove the soldering wire and then the iron.