Tin Soldering Iron Tip Without Flux

95-5 tinantimony solder is a low temperature lead-free solder with a narrow melting range.

Tin soldering iron tip without flux. When using the iron keep a little solder on the tip when the iron is in the stand. Use a cellulose sponge to wipe off the tip of the soldering iron. Ive successfully retinned several very bad irons.

But if any of these things are neglected in the soldering process you may need to re-tinner your tip. It will make your soldering iron long-lasting. If you over-clean the tip after use and then leave the iron in the holder there is a slight risk of oxide on the iron plating - I always clean and tin the tip immediately before using and leave any residual solder on the tip while its in the holder.

The name tinning comes from the fact that the alloy of solder consists of tin and lead combination. Wipe clean before using. It is primarily used for copper plumbing tube but can be used for other general soldering applications.

Always use clean fluxes. When the iron is not being used keep some solder on the tip. The solder should flow onto the tip producing a bright shiny surface.

Yes solder can be used without flux. The rapid melting characteristics require close fitting connections as it is difficult bridge or fill wide clearances. This is called tinning and it will help the heat flow from the irons tip to the joint.

Dont let it run dry. Melt a little solder on the tip of the iron. If the iron doesnt have replaceable tips get rid of it.