How To Use A Router Table As A Planer

It requires a straight bit and an offset fence.

How to use a router table as a planer. It is very easy to joint a board on a router table. Turn the table on its side and line up the mounting holes on the bottom of the plate with the correct securing points in the router which you identified earlier. With the high spot located raise the cutter and then lower it.

Put the router on the jig and pluge down lightly until you make contact with the work and lock the plunge depth. An insert that sits below or above the surrounding table can lead to an inaccurate cut or stop a workpiece in mid-pass. Using readily available lumber and a few specialty router bits anyone with a router table planer and table saw can make their own crown molding.

Feed the material from right to left. Its wide enough to securely hold the router mounted to an Infinity large router blaseplate 11-58 square. The router will be attached to the insert plate with bolts which are inserted into the plate and go through to the router base.

Diy router sled tutorial for the big make your router think it s a jointer easy and adjule diy router planer slab flattening mill woods. Using a combo-square mark lines across the jig at the edges of the hole. You can use an inverted table-mounted router to straighten narrow edges.

Place a spirit level on the router sled. Cut the lumber to width plane it to the correct thickness and begin routing the profiles on the face of the stock. Step 1.

This bridge is also just a fancy box. If you find your router pulling away from the straight edge your direction of feed is backwards. Remember the bit rotation from the top is clockwise so with your straight edge on the left make a push cut and the rotation will hold the router tight to the fence photo 13 - above.