How To Solder Wires Together With A Soldering Iron

At first take the solder near the male header and slightly touch the solder with the soldering iron.

How to solder wires together with a soldering iron. Lock and Firmly Twist the Stripped Wires Together. Move the iron to the opposite bottom side of the connection and repeat the same technique. You simply touch the freshly tinned tip of your soldering iron onto the bare wires for a couple of seconds and then apply the solder at which point it will smoke and flow over the wires almost immediately and you can withdraw the solder and then the iron and you should be left with a bright silver joint like the one below.

Makes it easier to easily solder wires together in tight areas. Ad Quality Solder Wire Drawing Machine. Using a Wire Stripper Strip the Wires to Desired Length.

Hold the two tinned wires on top of each other and touch both wires with the soldering iron. If you cannot afford the nichrome wire buy just a gas torch for less than 10 from the local hardware store. First you need to strip the wires then add your heat shrink tubing physically connect the wiressolder the wires together and then shrink that heat shrink tubing to make a waterproof connection.

How to solder standed wires like a professional. In this you have to use a soldering iron and melt the solder into the filaments. Place tip of soldering iron at the middle of the connection to activate the flux.

Keeping the tip of the soldering iron pressed in place move the solder wire along the wires coating it as you go. The flame of the torch will give off enough heat to solder wires together. Slide the iron to the end of the connection and then to the other end.

One is to touch the solder with iron and transfer this attached filler into the targeted tips directly from iron. Remove the soldering iron and wait a few seconds for the solder joint to cool and harden. This can be done by heating the wires directly and doesnt require any kind of a soldering iron.