How To Solder Wire Properly

You must tin the wire and the most.

How to solder wire properly. Learn How to Solder Correctly. Solder the Wire Joint. The reason the iron is placed on the backside and the solder wire to.

Keep the iron in place and touch the solder to the wire until its fully coated. Once the wires are hot enough there will be smokes as a sign of heated wires attach the solder on the heated location. Moreover soldering wires to the contact pads of the printed circuit board.

Set the iron to the solders temperature range. And allow the solder to melt. If you want to join two wires with solder the first thing you should do is to tin the two wires.

And then hold the soldering iron for 3-5 sec unless the Solder is melted. Some say its better to joint the two wires using a Y-splice while some only swear by the good ol rat tail splice. Lastly put Solder on the wire especially on the tip.

Tin coat with solder the soldering tip first. Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden. Preload the Soldering Iron Tip with Solder Wire.

Wrap one or two inches of solder around the tip while the iron is cold. Make sure to heat it before because of that the Solder melts and joints with the connector. The heated flux will evenly pull the melted solder into the wire.