How To Solder Small Wires

If you do need to use a littleadditional solder use the very thin kind about 2.

How to solder small wires. If you do it right you get a big melted bead ON the iron but with the wires running through the middle of it. Get a tiny ball of solder on the tip of your iron and touch it to the joint. I will show you how to solder wires together the right way to seal the solder joint with heat shrink is a must and you also need to make sure you do not have a cold solder joint.

Pinch the wire tip between the solder and the iron tip to tin and flow the wire end. Tiny wires sometimes only require a quick swipe across the joint to flow the tinned wires together. There must be a better way to do it.

I tried lower heat it burns off the enamel coating but leaves the wires black and solder will not stick. At this point you may want to trim the tinned end of the wire a little if it is too long. Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden.

I have been trying to solder the ends but not having much luck. Then twist the stands together. I apply the soldering iron tip and the solder to the metal tag near to where the tinned sleeve wire touches it and gradually introduce more solder until the molten blob touches the cable and melts.

Request a Quote Today. Soldering small wires to very small connections such as unused pins on QFPs You can DIY a tripod holder or just buy one probe tip makes the tripod. After you put the wire in a hole heat the junctionof the wire and hole until the solder on the wire and hole melt should take no more than 2 seconds.

Automotive wiring should be soldered and protected properly in order to withstand all types of weather rain snow and salt. Keep the iron in place and touch the solder to the wire until its fully coated. First place the solder on the tip to allow for melting.