How To Solder Electric Guitar Wires

Run the solder over the entire splice so it can melt and travel into the gaps between the wires.

How to solder electric guitar wires. Continue melting the solder until theres a thin layer of solder covering all of the exposed wire. Standard 6040 rosin-core is best and we prefer smaller 032-062 diameters for guitar wiring. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

Best Solder Guitar Electronics. If playback doesnt begin shortly try restarting your device. Work in a well ventilated areas.

Videos you watch may be added to the TVs watch history and influence TV. Place the items in a safe place where the screws or cover will not be lost. Twist the strands together apply the iron to the wire and then when its hot enough take a little solder to the wire as well.

On the below example this Strat copy guitar had a red wire for its hot and a bare un shielded wire for its ground further showing how different manufacturers can have different colour coding. Solder a wire from Tab 2 to the Tip Tab of the Output Jack then solder a wire from the Sleeve Tab of the Output Jack to the back of the Volume pot. The best solder for guitar wiring is standard 6040 rosin-core soldering wire.

You do not want a glob of solder on wire. Each washer was soldered to a loop of wire and then dropped down over the pots post just prior to installing the pot. Apply as little solder as possible here the aim is simply to hold the strands together and provide a surface that solder.

Resistance setting about 20K. To tin the wire simply heat up the exposed wire with the soldering iron and melt some solder on it. Do use rosin-core solder.