How To Clean Soldering Iron Without Flux

While it can be useful in certain situations it is not enough to remove oxidation from a soldering iron tip.

How to clean soldering iron without flux. Emptying the desoldered part and cleaning off the circuit board. Then dip into the tin of tinner cleaner with a slight twisting action. Wait till the Solder melts.

This will help the soldering iron to get back to the optimum room temperature. How to remove solder without. You also can clean your soldering iron tip with a sponge while using it to keep it clean.

Work quickly carefully and as close as possible to the soldering area for best results. I have also removed through hole components in days past by simply making the soldering iron a little hotter than usual applying a blob of solder to a joint to where it thoroughly liquifies the solder in the joint and then quickly whacking the board flat on a hard table with the bottom solder. No-clean flux is another alternative flux that is used for soldering parts that require little or no cleaning.

It will even shine a tarnished penny before your eyes. The best alternative to flux when soldering is petroleum jelly which is anti-corrosive and will not damage your material. Cleaning the iron is usually done with either a damp sponge or brass turnings.

Isopropyl alcohol is generally used for the removal of flux residues on circuit boards. Before cleaning let the soldering iron cool. To use the Tip tinnercleaner heat the soldering iron.

This helps to prevent unnecessary accidents. If you need to so some very small spot-work though you could get away without the flux but be aware it will likely bead up and roll around the wire instead of stick. Always wear gloves before you handle the ethyl and isopropyl solutions and start mixing them.