Make Your Own Pyrography Tips
It makes the pen tip glide across the surface of the wood easier and they are easier to clean.
Make your own pyrography tips. The tips are held securely in place with stainless screws. Your own unique design for your very own unique burn. I used a ball peen hammer to flattened after i shaped the tip part a round a needle nose pliers.
If you are impatient you could dip them in water. Plus it reduces the shock to the metal. Solder the exposed tips of the two copper wires to a power cord jack with a soldering iron.
Plug in the soldering iron and let it heat up. Thats about it I think. I think i even used an upholstery hammer to tap the hot wire on some.
You can use the wire razor tip provides or even one of their pre-exi. Anyone can be a pyrographer using this wood burner called Scorch Marker and a few scrap pieces of wood. You make your own custom tips from the tip wire see below.
Use only the special nickel-chromium wire. It seems that that tip alone is beyond the DIY. About 114 32mm long.
You can make them yourself but be sure to use the special alloy wire available in various weights to suit the job. It is a lot easier than you think to make your own and the wire shapes and flattens well when tapped with a hammer. Its Quite Simple to Make a Small Pyrography Tool and It Can Be Made at Home With Just Two Needles and Old Unnecessary Power Supply From Mobile Phone.