How To Turn A Hot Glue Gun Into A Soldering Iron

A soldering iron and a device to remove solder.

How to turn a hot glue gun into a soldering iron. Then the hot air gun is used to bring the component leads up to the solder melting pointThe theory is that this allows much shorter spot heating and less damage to adjacent components. Here you will learn how to do with your own hands homemade wood homemade electronics Christmas c. Twist the wire round.

Make sure the glue guns not plugged in if you do this as the mains cable may be wrapped close by the screw bosses. It involves using hot glue to position the battery box to the bases two-block sections. This is a soldering gun and this is a device that has much much higher power output.

Then put the blade into the groove and squeeze the soldering iron bit onto the blade using the vice. What Youll Need. Place your lead component through the hole.

Plug in the soldering iron and you are ready. Roll up the braidwool and lightly stuff it into the tip of the iron. You might find it has tamperproof screws.

This is made for soldering very heavy parts and they can even reach temperatures that are useful for silver soldering using for brass parts and. Razor blade or some nail clippers if the wart is small enough will. Once youre done use electrical tape to cover the two wires and fasten them together to form one block section of the base.

Wire optional hot glue gun or soldering iron optional Step 1. Insert the onoff switch into the notch securely and glue it in like this. If its for a project cut as needed using a pattern or template.