How To Solder Wires For Beginners

Make sure the tip is nice and clean.

How to solder wires for beginners. Hold it there for 3-4 seconds. A dirty circuit board wont solder properly and neither will a dirty component lead. Heat up your soldering iron and once fully heated touch the tip to one end of the wire.

You can do this tinning part in two ways. For soldering wire we need to tin the wires. Press your soldering iron right onto the wire connection and wait a few seconds for it to get nice and hot.

Joint both tinned wires together and heat up with solder iron for few seconds and remove iron to cool the joints. The copper on the board needs to be well copper coloured or shiny silver from being tinned and so do the component leads. Clean the tip on the sponge giving it a brief wipe.

Melt a small drop of solder on to the surface where the wire will be connected. Use heat shrink to cover the connection. Ad Low-Price High-Quality electronic Connectors Ready to Ship.

Note that the wire will get hot so you should consider holding it with some tweezers or similar. Repeat this process on the other wire. Some irons have temperature control so adjust to about 180 C or whatever is recommended for the solder wire.

Run the solder over the entire splice so it can melt and travel into the gaps between the wires. When necessary use desoldering braid to remove excess solder from a surface. Continue melting the solder until theres a thin layer of solder covering all of the exposed wire.