How To Solder Wires Correctly

Soldering Two Wires.

How to solder wires correctly. Note that the wire will get hot so you should consider holding it with some tweezers or similar. Use heat shrink to cover the connection. Tin the tip Tips for prolonging tip life making soldering easier.

Place the tip of the iron on the wire and let it heat for a few seconds. Install the ends of the wires into the holes on the board or into the sockets of the components in other cases. Apply Solder Flux to the Wire Joint.

Making a soldering litz wire is of as following. If you want to join two wires with solder the first thing you should do is to tin the two wires. To do this put the end of the stripped wire in rosin and heat it with a soldering iron - thereby bathing the wire in rosin.

Using the soldering gun heat the wiring up enough to melt the solder and gently apply the soldering to the wire with the soldering gun touching the wire. The process is carried out using a small amount of metal alloy known as solder and a heated handheld tool called a soldering iron. Keep the iron in place and touch the solder to the wire until its fully coated.

The wires will begin to heat up. Always place the soldering iron or gun UNDER the wires and add the solder to the TOP of the wire. Touch the tip of the soldering iron to the wires and keep it there.

Be careful to not overheat the wire and melt the insulation or allow the. You may select the dipping time as per your litz wire AWG size as below table. While there are probably a thousand different ways to do this there are also a thousand different ways to do it wrong.