How To Solder Radio Wiring Harness

Simple tutorial on the best way to connect the wires for a custom Automotive Radio.

How to solder radio wiring harness. Then the solder on the tip will flow right onto the back of the pot and itll stick. This tool worked the best for me in the automotive application and make it a breeze get that tuff to reach wires repaired soldered and sealed properly. Final assembly profile shall not impact form fit or function.

The key hot wire and ground wire is all I reused all other wiring is custom. I extended the accessory wire slightly by soldering and heat shrinking another 8 inches of 18-gauge Red wire to the one Pioneer included Step 3. If you dont have either of those you can wrap the wires with electrical tape.

Give us a Call. So I have to twist crimp or solder those connections. Ad Our Secret is our People.

After searching around for wiring info for the stock SVT sub and amp and unable to find any usable info. Then use a pair of pliers to push the metal tap down into both wires flush with the body of the connector and snap the cover over the tap. Ideally you should just replace the harness from one major connector to another if possible however in some cases this is not possible and soldering wires is the only remaining option.

Solder and shrink wrap wiring harness connections. These can be obtained from electrical stores. Solder the wires accordingly to these pins ensuring that the pins dont touch each other in the process.

The Becker harness plugs into the back of the head unit but I have to splice that harness to the cars harness. Ad One Stop Shop For Connectors. The location of splices shall be staggered to minimize the increase in profile to the harness.