How To Solder Car Wires Together

Strip about 34 inch of insulation from both wires.

How to solder car wires together. He prepares the wire ends by removing a quarter-inch of the shielding then twists the strands of wire together. The Easiest Way to Solder Wires Together. For this example we solder the same two 18 AWG wires together end to end.

Its the act of using heat via a soldering iron and a fusible metal the solder to create the electrical connection. Crimping will work well as Cougar suggested but if you really want the splice to be waterproof and permanent solder the wires then put heat-shrink tubing over the splice. The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently.

This tool worked the best for me in the automotive application and make it a breeze get that tuff to reach wires repaired soldered and sealed properly. Then use a pair of pliers to push the metal tap down into both wires flush with the body of the connector and snap the cover over the tap. Hold it on the wire for 3-4 seconds.

Once coated sufficiently move the shrink tube and heat it so it makes a snug fit around the wire. The wires can then be situated together by further twisting them blending them end to end or wrapping one around the other for a splice. When your soldering iron is all prepped and ready to go its time to solder the wires.

Soldering wires together is a part of almost any electronics project. I will show you how to solder wires together the right way to seal the solder joint with heat shrink is a must and you also need to make sure you do not have a cold solder joint. If youre not an old hand at soldering practice for a dozen or so joints before you try to do it under the dash with hot solder dripping on your cheek.

Now take these two wires and place them together in an X with the ends of the insulation in the centre of the X. In the first case make sure the bare end of the wire is at least long enough to make a half tun around the screw and always wrap it round the screw in the same direction as you will be tightening it. Youll also need some PVC shrink tube.