How To Solder Car Stereo Wires

Slide the existing wire into the open side of the connector then put the end of the wire you wish to connect to it into the other side.

How to solder car stereo wires. I have replaced speaker terminal boards and had to de-solder and then re-solder the tinsel leads. Next join both wires together and place the solder on top of them. 245 seems to flow a little different and it seems you have to leave the heat on a little longer.

After a few moments apply solder until it flows and covers the hole wire and tab near the speaker wire. Finally touch the solder with the soldering iron for a few seconds until the solder melts. Then heat them with the soldering iron and touch the solder to the wire after you heat it.

Insert the wire into the small holes in the speaker wire tabs. However sometimes you wont have access to a soldering iron. Heres a quick video with a pretty in depth explanation of wiring a harness.

Automotive applications use 6040 containing 60 tin and 40 lead. Using heatshrink will keep the joint from flexing. A little solder can go a long way when fixing cables.

Post dateAugust 8 2021. EASY- How to solder your car stereo wires. Now you have soldered your.

You melt the solder onto the wires to stick them together and as the solder cools it forms a permanent bond. May or may not be possible with some 65 and smaller drivers depending on the basket and the sizetype of heatsink. Then remove wire insulation before joining the wires together and place the hot soldering iron over the wires to join them with an iron strip together to the speaker or amplifier terminal.