How To Setup A Router Table Fence

You therefore need to set up the fence for your router table.

How to setup a router table fence. The router-fence itself being the T-squares crossbar with the long measuring unit sticking out perpendicular to the fence toward the rear-edge of the router table. The lower fence faces are secured with the. If you push the wood through from left to right the router bit will often grab the wood and fling it through the router table.

Ideally you want a 2-piece split fence whose center opening can be adjusted to minimize space on either side of the bit. All exiting through a 2-12 fitting on the left end of the table. Since the fence will overhang each side by 2 the width of these layers will also be 2.

The same operation with a handheld router or a table saw is often extremely cumbersome or dangerous. The ideal procedure to follow while doing this is to force the left side of your router table fence into a narrow space and then work on your work piece along a straight line. The fence operates like a large engineers T-square that is mounted on a sliding base on the surface of your router table.

The backer board will ensure that the cuts made are smooth and prevents the router bit from exiting on the ends. With all these done your router table should be ready for you. First get the fence as close as you can by eye.

You can now determine the type of wooden design you want to work on and then get down to it. The tricky part is the slot you can do it on your router table but the safe way is with the plunge router but if you dont have a plunge router drop a stick on top of the bit on the router and put in TWO slots1 12 long once you have the slots in place rip in down to size on the table saw once you have it down to the size you want to use take it back to the router table and put a rabbit cut on both. A router tables fence is its primary accessory.

For the example lets make a round router tablein this case there is no Fence parallel to the table edge which edge because the table is round. A router table can be set up in seconds to perform a stopped cut. Holding a steel rule against both fence faces pivot the loose end until the rule hits the mark you want.