How To Remove Tip From Weller Soldering Iron
Changing the soldering tips on a PES51 pencil is very simple.
How to remove tip from weller soldering iron. If it doesnt you need to remove all solder and grind the tip again more thoroughly. Melt some good quality of solder wire on the Tip. Im looking forward to buy 35mm copper wire instead and got it electroplated by nickel and iron.
The best tip tinner is your solder--tips should always be coated with a small amount of solder. To prevent burnout always keep the tip tinned with a thin coat of solder not only during soldering but also when the iron is sitting at idle in the holder. I will be using the iron to solder resistorscapacitors leds and ICs to veroboardstripboard.
And if you try to de- solder anything you will damage the tip. Damaging your iron is not only possible but easy when replacing the tips so procede with care. The flux in tip cleaner removes the oxidation and build up from the soldering iron tip and then the solder re-tins the tip ready for use.
Heat it up to around 350C and wait. The first thing of course is NOT to do this when the iron is hot. How to Tin or Re-Tin Soldering Iron Tip.
To have a soldering iron that works the way its intended it needs to be clean. You also can clean your soldering iron tip with a sponge while using it to keep it clean. Try not to leave the iron sitting hot on the bench while not in use.
Proceed to unscrew the locking nut holding the tip and the sleeve. Weller is a good manufacturer but be aware that there are two types of soldering tips. Could benefit from a new tip.