How To Remove Rubber From Exhaust Pipe

Soak a small pc of cloth and apply like a bandage.

How to remove rubber from exhaust pipe. Placing the rag over your fingers and rub the inside of the exhaust to remove any excess grime. Yes a torch works to but if u dont have it this works just as good. The hangers usually have a steel cord imbedded in the rubber.

Dont use abrasives Ive tried it 0000 bronze wool and WD-40 is just work and will still change the chromes texture. You actually start your bike to get the pipes hot and use a rag with the product applied to it to rub out the markings. If you are removing more than one hanger you might want to put a jack stand under the exhaust system to keep.

Get a thick rag or towel. Ride around to heat up the pipes. Jack up your car to replace the exhaust hangers.

Any tips would be greatly appreciated. Polish the exhaust pipe with the chrome cleaner-soaked. There is finally a product that is made for getting boot marks and other debris off your exhaust pipes.

It seems that the exhaust residue semi-bonds the rubber material to the elbow and the only solution Ive managed is to gradually work a screwdriver in working right round the joint. It will shrink the hanger and make room for the exhaust pipe to go out. Penetrating fluid of some sort to begin with helps.

The flat section at its end is about 50 mm long and once this has been pushed in about halfway it is possible to twistwriggle the hose free. I noticed a small less than a dime sized spot on my pipe by the passenger peg last night when I was polishing before winter storage. Secure the piping with muffler clamps.