How To Make Soldering Wire

Starting the soldering task and as I told we need first to set the soldering iron tip and then we heat it up once its ready to use you can notice that the soldering wire is molten easily.

How to make soldering wire. Diameter of copper core. Hold it on the wire for 3-4 seconds. At worst try RA Rosin Active flux.

Keep the iron in place and touch the solder to the wire until its fully coated. Using the soldering gun heat the wiring up enough to melt the solder and gently apply the soldering to the wire with the soldering gun touching the wire. The type of solder can make a difference when wiring small electrical wires.

Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires. This type of terminal barrel lends much better to crimp-then-solder than do pre-insulated terminals. The wires can then be situated together by further twisting them blending them end to end or wrapping one around the other for a splice.

You may select the dipping time as per your litz wire AWG size as below table. Touch the tip of the solder to the tip of the soldering iron to create a small pool of liquid solder on the irons tip. Tin the wires by applying a small amount of solder to the ends of each wire to just barely cover the wire.

Radio Shack sells a rosin core with a 6337 make upTypical general purpose solder but not recommended for our stuff. Dead link also not available on the Wayback Machine Similar to this wire. Using too much solder will make it difficult for the electrical current to pass through the wire with the additional resistance.

If desired you can clamp the wire in a third hand tool or similar heat-resistant holding device. He prepares the wire ends by removing a quarter-inch of the shielding then twists the strands of wire together. You interweave the threads of the wires together before soldering the joint solid.