How To Get Exhaust Rubbers Off

7 Take the rear wheel off so that you can get a good view of the exhaust mounting.

How to get exhaust rubbers off. I used a low angle on the razor and took my time. Just dont get it on paint like mentioned earlier and be careful because it spatters on the hot pipes. Once youve located the broken exhaust hanger remove the old one from both.

There may be three or four and theyre usually not too expensive. If the material is fairly easy to melt you may be able to use and old iron to melt or soften it up and then wipe it away with a cloth. I got the bolt off but cant seem to get the ring off it exhaust out.

Check out the black speck on the photo below. The scratches are generally very light and hard to see until you get them out in the sunlight. Most modern cars use some variation of the rubber donut to hang the exhaust.

Do you know how or what I am doing wrong. It takes it right off and shines the. If the rubber is thin and pliable enough the bulk of the material will come away from the metal.

Use a 14 drive ratchet with a short extension and 12mm from memory socket and reach around the back of the dump pipe to access it. Kawasaki Z1000 Ninja 1000 Z800 Z750 Z-750S. Where theres the will and a welder theres a way.

You may need to cut it off - you can use a stanley knife or even a junior hacksaw blade just dont cut anything else. 9 The old and new mountings. Once the exhaust cools with the rubber on there it is baked on and hard to get off.