How To Clean And Tin A Soldering Iron Tip

Usually touching the tip with rosin-cored solder will supply enough flux so that oxides can be removed with a damp sponge.

How to clean and tin a soldering iron tip. How to Tin or Re-Tin Soldering Iron Tip. That way the solder on the surface oxidizes rather than the tip itself. The best tip tinner is your solder--tips should always be coated with a small amount of solder.

If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the. This kind has a chisel-like shape and is also used for general-purpose soldering just as the B series tip. Never wipe it on the sponge and put it in the holder.

A polyurethane foam bar with embedded abrasives which is used to polish the working end of the tip to remove surface oxides. Soak the sponge using the water squeeze it out a little then use it to clean the tip of the soldering iron. Sit for a few minutes before wiping it clean.

The iron should NEVER be in the stand without a tinned tip Ie. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough. First you will want to heat the iron up to operating temperature and wipe the tip on a damp soldering sponge to gently clean it.

Plug in the iron and switch it on. You can file the black stuff off and make the surface smooth again. You also can clean your soldering iron tip with a sponge while using it to keep it clean.

Typically advised to be conducted after unpacking a brand new tool here are the steps on tinning a soldering iron. Using water soak the sponge that comes with the iron and squeeze it out a little. Alternatively you can use a special polishing bar particularly of.