Can A Router Table Be Used As A Jointer

It is a money-saving alternative to a dedicated pivotal jointer.

Can a router table be used as a jointer. However despite peoples unawareness you can use the Ryobi router table as a jointer. You may need to tweak it for your table. This is exactly how a jointer works the edge of the wood sliding onto the outfeed table after the knives cut it flat.

Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer layed on its side. Set the fence so the out feed half is even with the cutting edge of the bit. A router and router table are not manufactured with the purpose of edge jointing in mind.

A simple table saw jig will also do an excellent job of edge jointing a board so you may not need to wait until your router table arrives. While you dont necessarily need a router lift its a worthwhile upgrade to any router table. Take note of the spacing between the edge of the bit and the outer edge of the bushing.

The only difference is that we have the board laying down rather than standing up as on a true jointer. In this short video furniture maker and Fine Woodworking contributing author Gregory Paolini demonstrates his technique for jointing wood on the router table. Yes although there will be limitations to board depth based on bit size.

Photo 3 Photo 4. With the router unplugged use a square and a 12. Is it possible to use a router table as a jointer.

If your fence is 20 long then I would recommend jointing stock up to 36 or 13 longer than your fence. The rigid router fence will keep the laminate from flexing. By using a router table fence thats equipped with an offset fence youll be able to dial in the thickness of cut by adjusting the position of your infeed fence in relation to the outfeed side.